Actual Value Parameters - BONFIGLIOLI Vectron ACTIVE CUBE Série Guide Rapide

6.1.2

Actual value parameters

No.
211 R.m.s Current
212 Output Voltage
213 Active Power
240 Actual Speed
GB
241 Actual Frequency
259 Current Error
269 Warnings
273 Application Warnings
310 Last Error
783 SETUP adjusted motor
parameters
70
Description Unit
A
V
kW
1/min
Hz
-
-
-
-
-
Quick Start Guide ACU 201, ACU 401, ACU 501, ACU 601
Parameters relevant to ACU
Effective output current (motor current) of the frequency inverter
calculated from the measurement in the three motor phases.
Output voltage of frequency inverter modulated depending on the
operating point of the motor
Calculated power of the asynchronous motor at the current ope-
rating point. Product of output voltage, current and cosine phi
Speed of the asynchronous machine calculated using the machine
model and the current load point.
The current output frequency of the frequency inverter or actual
frequency of the drive calculated from the machine model.
The cause of the error-switch-off and the corresponding error key
are displayed. The current error is used for error diagnosis.
If a critical condition is detected, this condition is indicated by the
field WARN. The warning status can be displayed via parameter
269.
An application-specific warning can be read. For detailed func-
tions, refer to Operating Instructions.
The fault message is displayed immediately when a fault occurs.
The frequency inverter will try to acknowledge some faults auto-
matically, other faults will be reset via digital input S1IND. The
last fault code is saved for fault diagnosis.
The listed parameters (separated by commas) were changed by
motor commissioning.
If SETUP was not carried out yet, "No parameters adjusted" will
be displayed.
Explanation
05/16