5.3.
Menu guiding for SETUP configuration 700 –
synthetic network with preset reference
The data set change-over allows selection between four data sets.
Only the parameters in the selected data set are changed.
GB
D
05/ 2014
Setting Data Set
0
All Data sets (DS0)
1
Data Set 1 (DS1)
2
Data Set 2 (DS2)
3
Data Set 3 (DS3)
4
Data Set 4 (DS4)
Reference Frequency
Minimum: 0,00Hz
Maximum: 1000,00Hz
Default: 300Hz
801
Reference Voltage
Minimum: 0,0V
Maximum: 3000,0V
Default: 200,0V
810
Current Limit
Minimum: 0,0A
Maximum: depending on the device power range
Default: Maximum
Transformer V-Out/ V-In
Minimum: 0,00%
Maximum: 650,00%
Default: 50,00%
851 - Automatic voltage control
Operation Mode
Setting range: 0(Off) -122-220-321-322
Default: 0
(see table "additional advice about setting the parameter 851")
Max Feedback Voltage
Minimum: 0,0
Maximum: 6500,0V
Default: 298,5V
39
800
870
871
Quick Start Guide ACU-P