BONFIGLIOLI Vectron ACU-P Mode D'emploi page 42

5.4. Menu guiding for SETUP configuration 701 –
synthetic network with reference channel
 The data set change-over allows selection between four data sets.
 Only the parameters in the selected data set are changed.
05/ 2014
Confirm the „End" display by pressing the ENT-key.
The guided commissioning of the frequency inverter is terminated
via reset and the initialization of the frequency inverter.
After successful initialization of the frequency inverter the
factory- set parameter
If the digital inputs S1IND (Release A) and S7IND (Release B)
are activated then the output voltage is increased to the
set value
Voltage Reference
Setting Data Set
0 All Data sets (DS0)
1 Data Set 1 (DS1)
2 Data Set 2 (DS2)
3 Data Set 3 (DS3)
4 Data Set 4 (DS4)
Reference Frequency Source
0= internal (P. 800)
1= Reference frequency source with ramp
Default: 1
Reference Frequency Source
1= Abs. Value Analog Value MFI1A
10=Abs. Value Fixed Frequency (FF)
20=Abs. Value Motorpoti (MP)
Default: 111(MFI1A +FF)
Minimum Frequency
Minimum: 0,00Hz
Maximum: 999,99Hz
Default: 0,00Hz
40
842 is displayed.
Output Voltage
801.
872
475 (in extracts)
418
Quick Start Guide ACU-P
GB
D