Scope Of Delivery; Technical Data - Proxxon TG 125/E Traduction De La Notice D'utilisation Originale

In this way, soft and hard woods, plates, non-ferrous
metal or steel, even plastic, cork, rubber and many
further materials can be processed with high preci-
sion at grinding speeds of approx. 250-800 m/min
(adjustable).
The various fixing possibilities ensure particular flexi-
bility: Your TG 125/E can be operated both in "normal
position" and in standing, with the grinding table
removed. To this end, it is fixed with the enclosed
clamp.
The grinding table is made of high-grade aluminium
and can be adjusted upwards by 10° and downwards
by 50°. This also includes the guide slot for the angle
stop that is also included in the scope of delivery.
Two grinding wheels in each of the grain sizes offered
of 80, 150 and 240 are included in the scope of deliv-
ery.
In order that the swarf goes directly where it should,
namely into the vacuum cleaner, there is a connecting
piece to which the vacuum cleaner can be connected.
So you are optimally equipped for the grinding work.
3

Scope of delivery

1 x TG 125/E disc grinding machine
1 x Angle stop
1 x Connecting piece
1 x Rubber connector
2 x Grinding wheels grain 80
2 x Grinding wheels grain 150
2 x Grinding wheels grain 240
1 x Operating instructions
1 x Brochure with safety instructions
1 x Vice
4

Technical data

Dimensions and weights:
Length:
Width:
Height:
Weight:
Ø Grinding disc:
Dimensions grinding table:
Motor:
Voltage:
Power input:
Speed:
Grinding speed:
- 12 -
approx. 300 mm
approx. 140 mm
approx. 160 mm
approx. 3 kg
125 mm
98 x 140 mm
230 volt,
50/60 Hz
140 watt
KB 15 min
max. 3600 rpm
approx. 250-800 rpm
Noise development:
Vibration:
General measuring uncertainty: K=3 dB
Only in dry rooms
Please do not dispose of this electrical
machine in the household refuse!
Wear safety glasses!
Noise/vibration information
The information on vibration and noise emission has
been determined in compliance with the prescribed
standardised and normative measuring methods and
can be used to compare electrical devices and tools
with each other.
These values also allow a preliminary evaluation of
the loads caused by vibration and noise emissions.
Depending on the operating conditions while operat-
ing the device, the actually occurring emissions could
differ from the values specified above!
Please bear in mind that the vibration and noise
emission can deviate from the values given in these
instructions, depending on the conditions of use of
the tool. Poorly maintained tools, inappropriate work-
ing methods, different work pieces, too high a feed or
unsuitable work pieces or materials or unsuitable bits
and cutters (here: saw blade) can significantly
increase the vibration load and noise emission across
the entire work period.
To more accurately estimate the actual vibration and
noise load, also take the times into consideration
where the device is switched off, or is running but is
not actually in use. This can clearly reduce the vibra-
tion and noise load across the entire work period.
• Ensure regular and proper maintenance of your
tool
• Stop operation of the tool immediately if excessive
vibration occurs!
• Unsuitable bits and cutters can cause excessive
vibration and noises. Only use suitable bits and
cutters!
• Take breaks if necessary when working with the
device!
< 55 dB(A)
2,5 m/s 2
Warning!
Warning: