6.2 Notes on grinding speed
The grinding speed of your TG 125/E is infinitely
adjustable from approx. 250 – 800 m/min. In this way,
optimal adaptation to various material conditions is
possible. Please note that the circumferential speed
of the grinding disc is greatest at the edge and
reduces towards the middle.
General recommendations on the selection of the
grinding speed are difficult; it may be necessary to
experiment somewhat to find out the correct grinding
speed for "its" material and workpiece.
Based on experience, non-ferrous metals and plastic
require lower grinding speeds than soft and hard
wood; this also applies for ceramics and glass.
But as stated: Recommendations are difficult, the
correct speed depends on the material, contact pres-
sure and friction and grain size of the grinding
wheels.
7
Care and maintenance
Before cleaning, adjusting, service or repair, discon-
nect the mains plug!
Note:
The machine is largely maintenance free. To ensure a
long service life, however, the machine should be
cleaned with a soft cloth, handbrush or paintbrush
after each time it is used.
recommended here.
be used during work!
The outside of the housing can be cleaned with a
soft, possibly damp cloth. In this process, mild soap
or another suitable cleaning agent can be used. Sol-
vents or cleaning agents containing alcohol (e.g.
petrol, cleaning alcohols etc.) should be avoided,
since these can attack the plastic cases.
8
Disposal
Please do not dispose of this machine in household
refuse! The machine contains materials that can be
recycled. If you have any questions about his, please
contact your local recycling company or other rele-
vant communal facilities.
Caution:
vacuum cleaner is also
vacuum cleaner should always
9
EC Declaration of Conformity
Name and address:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation:
Article No.:
In sole responsibility, we declare that this product
conforms to the following directives and normative
documents:
EU EMC Directive 2014/30/EC
DIN EN 55014-1/05.2012
DIN EN 55014-2/02.2016
DIN EN 61000-3-2/03.2015
DIN EN 61000-3-3/03.2014
EU Machinery Directive 2006/42/EC
DIN EN 62841-1/07.2016
Date: 26.07.2018
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
The CE document authorized agent is identical with
the signatory.
TG 125/E
27060
- 15 -