Scope Of Delivery; Technical Data; Before Work; Setting Up Your Disc Grinding Machine (Fig. 2) - Proxxon TG 125/E Mode D'emploi

A high-precision manufactured and carefully
balanced grinding disc with double ball-bearing
direct drive guarantees excellent smoothness,
precision concentricity and minimum wear.
In this way, soft and hard woods, plates, non-
ferrous metal or steel, even plastic, cork, rubber
and many further materials can be processed
with high precision at grinding speeds of
approx. 250-800 m/min (adjustable).
The various fixing possibilities ensure particular
flexibility: Your TG 125/E can be operated both
in "normal position" and in standing, with the
grinding table removed. To this end, it is fixed
with the enclosed clamp.
The grinding table is made of high-grade alu-
minium and can be adjusted upwards by 10°
and downwards by 50°. This also includes the
guide slot for the angle stop that is also
included in the scope of delivery.
Two grinding wheels in each of the grain sizes
offered of 80, 150 and 240 are included in the

scope of delivery.

In order that the swarf goes directly where it
should, namely into the vacuum cleaner, there is
a connecting piece to which the vacuum cleaner
can be connected. So you are optimally
equipped for the grinding work.
3 Scope of delivery
1 x TG 125/E disc grinding machine
1 x Angle stop
1 x Connecting piece
1 x Rubber connector
2 x Grinding wheels grain 80
2 x Grinding wheels grain 150
2 x Grinding wheels grain 240
2 x Storage discs
1 x Operating instructions
1 x Brochure with safety instructions
1 x Vice
- 12 -
4

Technical data

Dimensions and weights:
Length:
Width:
Height:
Weight:
Ø Grinding disc:
Dimensions grinding table: 98 x 140 mm
Motor:
Voltage:
Power input:
Speed:
Grinding speed:
rpm
Noise development:
Only in dry rooms
Protection-class-II machine
Please do not dispose of this electrical
machine in the household refuse!
5

Before work

5.1 Setting up your disc grinding
machine (fig. 2):
Note:
When setting up the machine, make sure that
the ground below it is level and secure! A secure
stand is indispensable for working with the
machine!
Note:
When setting up and fixing the machine, always
disconnect the mains plug to prevent the disc
being started up accidentally. Risk of injury!
The disc grinding machine can be operated in
two different positions: Once in the normal
approx. 300 mm
approx. 140 mm
approx. 160 mm
approx. 3 kg
125 mm
220 - 240 volt,
50/60 Hz
140 watt
max. 3600 rpm
approx. 250-800
< 55 dB(A)