Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents:
• Winch
IDENTIFICATION KEY
A
Motor Terminal
B
Motor
C
Hawse Fairlead
D
Rope on Drum
E
Clutch Hand Wheel
F
Tethered Remote
G
Clevis Hook with Latch
H
Hook Strap
I
Solenoid
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
MOUNTING THE WINCH
Four 5/16 in. screws, lock washers, washers and nuts, SAE Grade 5 or higher,
are required to permanently mount the winch. This hardware is not included
with the winch.
1.
Choose a location on the vehicle that can withstand the stress of the
maximum weight capacity (see Specifications). Install a steel
reinforcement plate or additional bracing to strength the location.
2.
Make sure there is adequate room for the winch and a flat surface for
it to sit on. Verify the structure where the bolts will go contains no
hidden wiring or components. Relocate either the winch or the
wiring/components if there is overlap.
3.
Mark the holes along the center using the winch' s base as a template.
Reach through the front or back opening to make the marks.
4.
Drill each hole with a 5/16 in. drill bit to accommodate the bolts.
5.
Position the winch to align the bolt holes on the bottom with the pre-
drilled holes.
Visit www.princessauto.com for more information
12V DC Winch
• Tethered Remote • Mounting hardware
8964793
7
Publicité
Table des Matières
