Assembly & Installation - Power Fist 8843104 Mode D'emploi

V1.0
14. Do not move vehicle with cable extended and attached to load to pull
it. The cable could snap.
15. Apply blocks to vehicle when parked on an incline.
16. Re-spool cable properly.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
1. Carefully remove the winch from the package.
a. Retain packing material until you have carefully inspected and
satisfactorily installed and operated the winch.
2. Inspect the parts carefully to make sure winch was not damaged while
shipping.
IDENTIFICATION KEY
A Crank Handle
B Ratchet Switch
C Axis Bolt
D Base
E Drum
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
MOUNTING
Mounting structure must be capable of withstanding
loads within the capacity of the winch (see
Specifications). For increased strength and safety,
this winch should be mounted with three 3/8 in. or
M10 bolts, washers, lock washers and nuts (Fig. 2).
HANDLE
Install the handle (#19) on the shaft bolt (#1) and
secure with a lock nut.
Visit www.princessauto.com for more information
Hand Winch With Cable 8843104
5