Before First Use - Power Fist 8964793 Manuel

V1.0
d. Attach the brown wire (Fig. 2-9) to the small screw on the left.
e. Ensure all screws are tight.
8. Connect the red wire (Fig. 2-10) to the positive battery post.
9. You can reverse the
remote by switching the yellow wire (Fig. 2-2) to the motor' s negative
terminal (Fig. 2-4) and the blue wire (Fig. 2-5) to the motor' s positive
terminal (Fig. 2-3). Disconnect the battery when making this change.
OPERATION
WARNING! Do not release the clutch while the winch is pulling a load. It may
cause the load to shift or move unexpectedly and the wire may snap with
the unexpected stress. Either may cause death or severe injury to the user
or bystanders.

BEFORE FIRST USE

The steel cable must be broken-in before using to pull a heavy load. The
break-in process will stretch the cable, ensure the individual wires are
seated and the wire compacted. Run the winch with a light load of
approximately 500 lb several times, before normal use.
Also use the weight when spooling the cable onto the winch. This will
provide the correct tension when spooling.
OPERATION
1. Make sure the operator can safely control the winch before performing
any functions with it and that they are familiar with all safety and
operating instructions.
2. Inspect the winch, steel cable and terminal tackle before each use. Replace
any damaged or frayed components before use.
3. Connect the winch to a 12VDC power supply
(see Wiring).
4. Turn the clutch hand wheel (E) clockwise a
quarter turn to disengage the brake (Fig. 3).
5. Pull out the cable by the hook strap (H) until
you have the desired length out.
a. Make sure there is always five turns of
cable on the winch drum.
6. Attach the steel cable to the load with a
hook, shackle, sling or chain capable of
Visit www.princessauto.com for more information
12V DC Winch
power in power out
and buttons on the tethered
8964793
Fig. 3
9