Dismantling And Repairs - Festo CLR 0312NH Notice D'utilisation

CLR−...
10

Dismantling and repairs

For all dismantling and repair work:
Exhaust the CLR−... .
S
Removing the clamping finger
1. Fasten the clamping finger with the
head of the screw upwards in a vice.
2. Unscrew the fastening screw one turn
out of the clamping finger.
3. Fasten the clamping finger turned
180° in the vice as shown in Fig. 25.
4. Turn the piston rod at spanner flat 6
with a spanner. The piston rod will then
be released from the clamping finger.
An alternative is an extractor device
(e.g. if it is not possible to dismantle
the CLR−...).
Order the wearing parts as specified.
S
Always send defective articles to Festo.
S
Make sure that the CLR−... is overhauled only by our repair service.
S
The repair procedures require settings with very accurate adjustments.
Explain the fault and the conditions of use in an accompanying letter.
Festo CLR−... 0312NH English
Fig. 24
Fig. 25
31