Hydraulic Connection - Hayward MICRO HP2021DT3C Manuel D'instructions Et D'installation

4. INSTALLATION AND CONNECTION (continued)

4.3 Hydraulic connection

The heat pump comes with two 32 mm/38 mm fittings.
► Wrap the threads of the fittings 15 to 20 times around with teflon.
► Screw in the two fittings as indicated in the figure below.
► Connect the bypass kit (1) and the pipes, following the direction of
circulation indicated in the figure.
See also the diagram on page 8.
► Once the device has water running through it, verify that the connection is
watertight. Add teflon if there is a leak.
Water outlet
Water inlet
Fittings
Bypass kit
towards (4) and the pool
from the pool
and the pump (2-3)
9