Brinly SA2-40BH1-G Guide D'utilisation page 8

Step 1-B
1. Align the Clevis (20) to
the Drawbar (3).
- Attach the clevis from beneath with two
5/16" x 1" Hex Head Bolts (11).
- Secure with two 5/16" Nylock Nuts (12).
NOTE: Leave nuts loose on this step, allowing the End Panels (1) to be adjusted later.
Step 2
Align an End Panel (1)
with the Aerator Tray (5).
- From beneath, run three
5/16" x 3/4" Hex Head Bolts (10)
through the tray and end panel.
- Add a 5/16" Flat Washer (14) to each bolt.
- Add three 5/16" Hex Nuts (12), DO NOT TIGHTEN FULLY.
NOTE: These will be adjusted and secured on Step 4-B.
Repeat on the other end of the tray (5).
English Manual
ASSEMBLY
12
11
+
14 12
10
8
12
11
x2
12
14
10
x6
1019097-B