Maintenance - Brinly SA2-40BH1-G Guide D'utilisation

MAINTENANCE

- The key to years of trouble-free service is to keep your Aerator clean and dry.
- After the first 30 minutes of use, check all fasteners for tightness. Thereafter, periodically check
all fasteners for tightness.
- Tines are manufactured with galvanized steel to resist
wear of abrasive soil. Striking objects can cause Tines
to curl or break. Contact Brinly-Hardy customer service
department to purchase replacement Tines.
- Apply a light coat of oil on tines
after use to prevent rust.
AFTER USE, THE TINE AND TINE BEARINGS MAY BECOME LOOSE ON THE TINE SHAFT.
Should this occur, remove the
looseness as follows:
1. Loosen
the End Panel
nuts (A).
2. Push the
End Panels (1)
toward the Tines
until there is no
free play along the
Tine Shaft.
3. Tighten the
End Panel nuts (A).
NOTE: The Square Bearings must be completely inserted into
the End Panels before you tighten the End Panel nuts (A).
English Manual
MAINTENANCE
1
A
- For rust appearing on painted surfaces, sand
lightly and paint affected area with enamel.
- Periodically remove debris that
builds up between Tines.
- Apply lubricating oil at each tine bearing and axle
bearing before use.
14
1
A
1019097-B