Preparation - Dimplex XLE Serie Mode D'emploi

Preparation

1. Place the heater within its packaging
flat on the ground with arrows printed
on the base of the carton pointing
upwards.
2. Feet are fitted in the default position
(X position) and can be moved to
the outside position (Y position) if
necessary. (Fig. 1a and Fig. 1b). NB:
Repositioning of feet may be required
depending on floor arrangement (e.g.
replacing an installation).
Stand the heater on its feet before
removing the packaging.
CAUTION SHOULD BE TAKEN NOT TO
REST THE HEATER UPON THE ROOM
TEMPERATURE SENSOR HOUSING. (Fig. 1b)
Dispose of packaging in an appropriate way.
Read these instructions carefully before
proceeding any further with the installation.
3. Ensure the heater is stable before removing the screws which hold the bottom grille
panel in position. (Fig. 2) Set the bottom grille to one side, avoiding its sharp edges
when handling.
4. Remove the two screws securing the front panel, located at the bottom of the heater
(Fig. 3). Once removed set carefully to one side to avoid damage.
NOTE - Retain these screws for reassembly. If misplaced, M4 x 10 Tritap screws must be
used. IMPORTANT - Do not use the outer top panel or the rear heat shield to lift or carry
the heater.
6
Fig. 1a
Y
X
W
150mm
(min)
A B
Models 050 070
Feet Position
167/124 167/185
1 'A/B'
Feet Position
93/198 93/259
2 'A/B'
150mm
(min)
B A
100 125 150
167/246 160/314 160/375
93/320 100/374 100/435
Fig. 1b
X
Y
Room Sensor
Housing