Dimplex XLE Serie Mode D'emploi page 27

Landlord Lock Mode
Introduction
This appliance has a built in Landlord lock mode, when this mode is activated all
functionality of the Boost and Setback is locked and the user will have no ability
to select or adjust timer mode. It is possible to limit the maximum operating
temperature in the Landlord mode.
Operation in Landlord Lock Mode
When Landlord Lock mode is active the specific appliance modes are locked, it is not
possible for the user to adjust predetermined comfort periods. During these periods
the appliance will control the room to a desired temperature. The set point can be
adjusted by the user however it is possible to assign a maximum set point limit during
the Landlord Lock mode setup. Once the Landlord Lock mode is disabled, the use
of Boost and Setback modes and selection/adjustment of timer mode are enabled.
To activate Landlord Lock mode the user must enter service menu first. Back, Menu &
Enter must be pressed simultaneously and held for 10 seconds. To access the Landlord
Lock menu the user will be prompted to enter the Landlord Lock PIN.
Enabling Landlord Lock Mode
After correct PIN entered, select Enable using Enter. Landlord Lock mode will be
enabled, normal functionality of the appliance will be disabled allowing only the
functionality determined by Landlord Lock.
Disabling Landlord Lock Mode
After correct PIN entered, select Disable and confirm using Enter. Landlord Lock will
be disabled and full appliance functionality will be enabled.
Ou t Al l Day
Co mfort On
Ou t Al l Day
Co mfort On
Se r v i ce
C ha rge Ti m e
S lave Mo d e
La nd lo rd Loc k
R m Te mp Of f s e t
La nd lo rd Loc k
C hang e Co d e
Bo o st Lo c k
Se t ba c k Lo c k
Tim e r Mo d e
Lo c k
Ma x Tem p
NOTE:
The default password is 0000,
the password can be changed from
within the Landlord Lock mode menu.
L a nd l o rd Lo c k
E nte r Co de
0 0 0 0
L a n dl o rd Lo c k
D i s a b l e
E n a b l e
27