Finishing; Cast Front Installation And Removal; Safety Barrier Installation And Removal - Napoleon Bayfield GDS25N-1 Manuel D'installation Et D'opération

4.0 fi nishing
EN
WARNING
!
• Risk of fi re!
• Never obstruct the front opening of the appliance.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
4.1

cast front installation and removal

WARNING
!
• Glass may be hot.
• Do not touch glass until cooled.
A.
Remove safety barrier.
B.
Lift the top cast piece off of the
appliance.
C.
Detach the front cast piece from
the side pieces by removing the
screws from the brackets located
in the upper inside corners.
D.
Slide the front straight up to
remove.
Follow the above steps in reverse in order
to reinstall the cast front. Ensure that
the tabs on the underside of the front fi t
behind the front legs.
note:
It is not necessary to remove the cast front in
order to remove the door.
4.2

safety barrier installation and removal

A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the appliance
and shall be installed.
A.
Lift the top casting up and remove the safety barrier. Remove and discard plastic.
B.
Tilt the top of the safety barrier and hook under the top casting, make sure to hold the safety barrier.
C.
Slightly lift the bottom of the safety barrier and push onto theappliance. Careful not to scratch the bottom
casting.
D.
Reverse these steps to remove.
24
W415-2347 / C / 09.21.20
Screws
Front
Bracket
Front
Tab
Door
Retainer
Front Legs