Memorisation Of The Gate Leaf Length (Opening And Closing); Memorisation Of The 1 St Transmitter - Nice Filo400 Instructions Et Avertissements Pour L'installation Et L'utilisation

Masquer les pouces Voir aussi pour Filo400:

Notice de programmation (2 pages)

Table des Matières

Les langues disponibles

A A erial

Aerial

5.4 - MEMORISATION OF THE GATE LEAF LENGTH (opening and closing)

After recognition of the devices (Par. 5.3) it is necessary to make the control unit memorise the length of the gate leaf, which is measured from the

closing limit switch to the opening limit switch. This operation is also required to calculate the deceleration points and the partial open point.

01. Release the gearmotor (see paragraph 11.3 – User's guide) and move the gate to mid-travel so that it is free to move in both the opening and

closing directions; then lock the gearmotor.

02. On the control unit (Fig. 18) press and release button P1: wait for the control unit to execute the gate opening manoeuvre up to the opening limit

switch. Only if the manoeuvre is NOT an opening movement, proceed as follows: a) press and release button P1 to lock the manoeuvre – b)

shut off power to the control unit – c) invert the position of the selector on the control unit (Fig. 19) – d) restore power to the control unit – e) repeat

the learning procedure for the connected devices described in Paragraph 5.3 - MEMORISATION OF CONNECTED DEVICES - f) press and release

the P1 key.

03. On the control unit (Fig. 19) press and release button P1: wait for the control unit to execute the gate closing manoeuvre up to the closing limit

switch.

Aerial

04. Lastly, perform various opening and closing manoeuvres while checking that the gate leaf stops at least 2/3 cm from the mechanical stops during

both the opening and closing phases (Fig. 20). If this distance does not match the proper distance, modify the position of the limit switches.

5.5 - MEMORISATION OF THE 1

The control unit incorporates a radio receiver for ECCO5 transmitters (various models): before proceeding with the remaining steps, it is necessary to

memorise the 1

transmitter in Mode 1 – see procedure below.

To memorise additional transmitters, see Par. 9.3.

Before running the memorisation procedure, it is advisable to read it and observe the indicated times.

This procedure allows for simultaneously memorising all the transmitter keys, by automatically pairing them to the commands shown in Table 1 below.

A transmitter memorised in Mode 1 can control only a single automation.

7 – English

Flash

Fuse 1.6A T

ECSbus