Safety Instructions - SilverCrest SDB 2400 A1 Mode D'emploi

Masquer les pouces Voir aussi pour SDB 2400 A1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Safety instructions

DANGER – ELECTRIC SHOCK!
The rating of the local power supply must correspond with the details given
on the rating plate of the appliance.
To avoid potential risks, arrange for a defective appliance to be checked
and possibly repaired by qualified technicians, or contact our Customer
Service Department.
To avoid risks, have defective plugs and/or power cables replaced immedi-
ately by qualified technicians or our Customer Service Department.
Always disconnect from the mains power socket by pulling only on the plug
itself, never on the mains cable.
Never bend (kink) or crush the power cable, always route it in such a way
that it cannot come into contact with hot surfaces and such that no-one can
step on or trip over it.
After every use, before cleaning and when refilling with tap water, always
remove the plug from the mains power socket.
Always unroll the power cable fully before switching on and do not use an
extension cable.
Never touch the power cable or the plug with wet hands.
Never use the steam iron adjacent to water contained in a bath, shower,
wash basin or other vessels. The proximity of water is hazardous, even if
the appliance is switched off.
Under no circumstances should you submerge the steam iron in any liquid
or permit liquids to penetrate into the housing of the steam iron. Do not
expose the appliance to moisture and do not use it outdoors. If liquid gets
into the housing, disconnect the appliance from the mains power socket
immediately and have it repaired by a qualified technician.
You may not open the steam iron appliance housing. Have a defective
appliance repaired only by an authorised technician.
SDB 2400 A1
GB
IE
3

Publicité

Table des Matières

Dépannage

loading

Table des Matières