Tylo SENSE COMBI Pure Notice D'installation page 17

11. Fit the cover for the water reservoir, herb grille and fragrance
holder/air humidifi er (see Figure 13).
Fig 13: Fitting the cover for the water reservoir, herb grille and
fragrance holder/air humidifi er
12. Install the sensor on the wall see Fig 14 and 15. The thermi-
stor wire may also be passed through the wall see Fig 16A
and 16B. Seal any holes in the wall behind the sensor. The
thermistor wire may be extended outside the sauna using low
voltage wire (2-, 4-lead).
Figure 14: Installing the sensor - Combi Pure
Fig 15: Installing the humidity- and temperature sensor - Combi
Elite. The cable inside the sauna must be heat resistant. Connect
the sensor cable (see Figure 18).
Figure 16A: Wiring through the wall. The example shows the
sensor for Combi Pure.
Combi Pure
Fig 16B: Wiring through the wall. The example shows the sensor
for Combi Elite. Connect the sensor cable (see Figure 18).
Unusual voltages/numbers of phases
Contact Tylö Customer Service before connecting to voltages or
Combi Elite
numbers of phases that are not listed in the wiring diagram Figure
17.
External ON/OFF switch (option)
External ON/OFF switch can be installed anywhere outside the
sauna. The switch works for impulse or constant deactivation.
The heater circuit automatically recognises which is used. Heater
status and faults on the door contact can be seen if the switch has
a built-in LED.
See instructions supplied with the external switch.
Door contact (option Combi Pure)
The door contact is necessary to be able to use the Pure panel's
preselected time or the Elite panel's calendar function, plus remo-
te control the sauna via external switch, mobile or PC apps.
See instructions supplied with the door contact.
Min. Ø13mm
15