Operating The Myspin 6 In A Remote; Environment; Rotor Replacement - Thermo Fisher Scientific mySPIN 6 Manuel D'instructions

Operating the mySPIN 6 in a Remote

Environment

1. Place the mySPIN 6 on a sturdy, level surface away from the edge of the
counter and other moving equipment.
2. Verify that the power switch is in the OFF position.
3. Plug the 12 V car adapter into the car cigarette lighter socket.
4. Press the power button
5. Follow step 7 to step 10 from the procedure above in
mySPIN 6 in a Lab
6. Remove the adapter from the car.
CAUTION
avoid any damages.
The unit must be sealed securely and locked when carried with
Notice
samples enclosed.

Rotor Replacement

To remove SnapSpin™ rotor: Press center button firmly and at the same time lift
rotor upwards.
To install SnapSpin™ rotor: Set rotor onto the hex shaft. Press center button
firmly and downward. Rotor shall latch with a click sound.
10 | Operation
on the centrifuge.
.
Prevent any twists or bends to the adapter cable to
Operating the
mySPIN 6 Instruction Manual