FUTURO 136750 F4 Mode D'emploi page 67

Control
Attribute
command
POSE
POSD
1 ZERO
1, 2 PRE
1, 2 PRE+{num}
PRE?
REFx
1 RES2
1 RES3
RST
UNI?
1 UNI1
1 UNI0
VER?
VER1?
VER2?
VER3?
PCAL?
NCAL?
LCK+{seq}
ULK+{seq}
LN20
LN21
PONCE[1|0]
PONCE?
1, 2 CHHOLD
1 CONST
CONST?
ERR?
!ERR
UERRE
UERRD
Description
Used to activate the automatic printing of the position following a movement.
Used to deactivate the automatic printing of the position following a movement.
Used to initialise the display to zero
Used to show the preset value.
Used to register the preset value.
Used to print the preset value.
Used to select the entered reference (whereas 'x' corresponds to a value between 1 and 9)
Used to fix the resolution at 0.001 mm or 0.00005 in.
Used to fix the resolution at 0.01 mm or 0.0005 in.
Used to reset the instrument (same effect as "ERR").
Used to print the current measurement unit.
Used to activate the conversion from inches to millimetres.
Used to deactivate the conversion from inches to millimetres.
Used to print all firmware versions of the instrument with a title.
Used to print the module version without a title.
Used to print the mainboard version without a title.
Used to print the sensor version without a title.
Used to print the last calibration date.
Used to print the next calibration date.
Used to lock specific keys. (whereas 'seq' = '0123456789.E' and '+' or '-')
Used to unlock specific keys. (whereas 'seq' = '0123456789.E' and '+' or '-')
Used to deactivate the second row of the display.
Used to activate the second row of the display.
Used to activate or deactivate the "Print once" function.
Used to print the status of the "Print once" function.
Used to select the Probe holder change function.
Used to select the probe constant function.
Used to print the probe constant.
Used to print the most recent error message.
Used to reset the error message
Used to activate the error mode (instrument is blocked following an error)
Used to deactivate the error mode (double sound signal following an error)
29