Steris BioGuard 00711785 Mode D'emploi page 4

8. Release the BioGuard
9. Keep the distal end of the scope in the basin of water.
10. Flush air for the recommended time per the scope manufacturer's reprocessing instructions.
Note: Air bubbles will be seen in the basin of water.
11. Turn off the air/flow regulator on the light source.
12. Remove distal end of scope from basin of water.
13. Remove the BioGuard
Remove and discard the BioGuard
connector, and the BioGuard
Product Disposal:
After use, these products may be potential biohazards which presents a risk of cross-contamination. Handle and dispose of in
accordance with accepted medical practice and applicable local, state and federal laws and regulations.
Issued Date: October 2019
Warning: An issued or revision date for these instructions is included for the user's information. In the event that two years have elapsed
between this date and product use, the user should contact STERIS to determine if additional information is available.
Unless otherwise indicated, all marks denoted with ® or ™ are registered with the U.S. Patent and Trademark Office, or are trademarks
owned by STERIS Corporation.
Serious incidents that have occurred in relation to this medical device should be reported to the manufacturer and competent authority in
the country where the incident occurred.
US Endoscopy, a wholly owned subsidiary of STERIS Corporation.
®
Olympus is a registered trademark of Olympus corporation.
00732820 Rev. C
®
air/water cleaning adapter.
® air/water cleaning adapter from scope after precleaning step is completed.
® air/water suction valves, the BioShield
® air/water cleaning adapter after each use.
® biopsy valve, the Torrent ® irrigation scope
4 of 46