Automatic Vacuum & Seal Mode - Weston 65-0501-W Mode D'emploi

AUTOMATIC VACUUM & SEAL MODE
1. Attach the Vacuum Sealer to the
power supply.
2. Press the ON/OFF Button
(FIGURE 6) on the Control Panel
to turn the Vacuum Sealer "ON".
The ON/OFF Button on the display
will illuminate and the Internal
Cooling Fan will run.
3. Press both of the Lid Release
Buttons (FIGURE 7) on each side
of the Vacuum Sealer to release
the lid lock, then lift the Vacuum Lid
to open.
4. Fill the vacuum bag with the
product to be vacuum sealed. The
open end of the vacuum bag must
be clean and dry to seal properly.
HINT: When filling bags, fold over
the top portion of the bag, fill the
bag, then unfold the top portion to
seal (FIGURE 8).
5. Place the open end of the bag
onto the Vacuum Chamber Seal
and slightly into the Vacuum
Chamber (FIGURE 9). The
Vacuum Post cannot be blocked
or covered by the bag. Make sure
there are no wrinkles or creases in
the bag in the sealing area.
6. Push down and close the
Vacuum Lid and lock into place.
The open end of the bag should be
sandwiched between the Seal Bar
Insulator and the Seal Bar Heating
Element/Seal Bar Tape.
7. Press the START Button
(FIGURE 6), the Vacuum Pump
will engage. The START Button
will remain illuminated while
vacuuming.
WARNING!
appliance, make sure the appliance is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
Seal
Insulator
Vacuum
Chamber
Seal
Seal Bar
Heating
Element/
Seal Bar Tape
Before cleaning, assembling or disassembling the
Control Panel
Lid
Lid Release Button
On both sides of the
Vacuum Sealer
Bar
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9
Vacuum Post
Vacuum
Chamber
9