Vacuum Chamber Seals; Cooling Fan; Outlet Instructions - Weston 65-0501-W Mode D'emploi

VACUUM CHAMBER SEALS

The Vacuum Chamber Seal
may wear over time and
require replacement. See the
"Service Instructions" section
of this manual for information
on replacing the Vacuum
Chamber Seal, if necessary.
FIGURE 2

COOLING FAN

The Vacuum Sealer has an
Internal Cooling Fan that runs
whenever the unit is plugged
in and turned on. To save
energy, turn the unit "OFF"
and unplug the Power Cord
when not in use.
Do not block the Fan Vent
(FIGURE 3) on the bottom of
the Vacuum Sealer. Keep the
area clear to allow for proper
air circulation.

OUTLET INSTRUCTIONS

To reduce the risk of electrical shock, this plug must fit
fully into the outlet. If the blades do not fit into the outlet,
try turning the plug around. If the plug still does not fit into
the outlet, contact a qualified electrician. DO NOT attempt
to modify the plug in any way.
Vacuum Chamber Seal
Cooling
Fan Vent
Vacuum
Chamber
Lid Seal
BOTTOM OF
VACUUM SEALER
FIGURE 2
Seal Bar
Insulator
FIGURE 3
7