Protective Tape; Cleaning - Weston 65-0501-W Mode D'emploi

PROTECTIVE TAPE

strip of Seal Bar Tape on the Vacuum Sealer.
DO NOT REMOVE THE TAPE!
SEAL BAR TAPE
DO NOT
REMOVE!
The Seal Bar Heating Element is
covered with Seal Bar Tape to protect
vacuum bags during sealing (Figure 1).
DO NOT remove the Seal Bar Tape.
See the "Service Instructions" section of
this manual for information on replacing
the Seal Bar Tape, if necessary.
CLEANING INSTRUCTIONS
WARNING!
appliance, make sure the appliance is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
1. Press the ON/OFF Button on the Control Panel to turn the Vacuum Sealer
"OFF".
2. Disconnect the Vacuum Sealer from the power supply.
3. Make sure the Vacuum Sealer is completely cool.
4. NEVER IMMERSE the Vacuum Sealer in water or other liquid. Wipe clean
all outside surfaces including the Vacuum Chamber and Vacuum Lid with a
damp cloth or paper towel. Most household spray cleaners are safe to use.
Avoid spraying directly into the vent on the left side of the unit. DO NOT use
abrasive cleansers or steel wool!
NOTE: Be careful while cleaning not to peel or damage the strip of Seal Bar
Tape covering the Seal Bar Heating Element .
5. Dry all surfaces and close the Vacuum Lid before storing the Vacuum
Sealer.
6
There is one factory installed
Before cleaning, assembling or disassembling the
FIGURE 1