Vacuum Sealer Canisters - Weston 65-0501-W Mode D'emploi

VACUUM SEALER CANISTERS

Vacuum canisters may
be used with the Vacuum
Sealer (Sold Separately).
Vacuum canisters come with
their own hose.
1. Attach the Vacuum Sealer
to the power supply.
2. Press the ON/OFF Button
(FIGURE 12) on the Control
Panel to turn the Vacuum
Sealer "ON". The ON/OFF
Button on the display will
illuminate and the Internal
Cooling Fan will run.
3. Insert one end of the
accessory hose into the
Accessory Port (FIGURE 13)
on the Vacuum Sealer.
4. Insert the other end of the
accessory hose into the port
on the lid of the canister.
FIGURE 14
5. Fill the canister with
the product to be vacuum
sealed.
6. Turn the knob/dial on the
canister to the seal position.
7. Press the ACCESSORY Button (FIGURE 12), this will engage the Vacuum
Pump. The ACCESSORY Button on the display will illuminate while vacuuming. The
appliance will stop automatically and "BEEP" when the seal process is complete.
8. Gently remove the accessory hose from both the canister and the Vacuum
Sealer. Wait at least 20 seconds before vacuuming another canister to avoid
overheating the unit. Be careful not to turn the knob/dial of the canister to the open
position.
9. To test vacuum, gently tug on the canister lid. The lid should not move.
10. To release the vacuum and open the canister, turn the knob/dial on the
canister to the open position.
11. Press the ON/OFF Button on the Control Panel to turn the Vacuum Sealer
"OFF".
12. Disconnect the Vacuum Sealer from the power supply.
12
(SOLD SEPARATELY)
Control Panel
Accessory
Port
Accessory Hose
Sold Separately
Accessory Canister
Sold Separately
FIGURE 12
FIGURE 13
FIGURE 14