Marinating With Canisters - Weston 65-0501-W Mode D'emploi

MARINATING WITH CANISTERS

Vacuum canisters may be used with
the Vacuum Sealer (Sold Separately).
Vacuum canisters come with their own
hose.
1. Attach the Vacuum Sealer to the
power supply.
2. Press the ON/OFF Button (FIGURE
15) on the Control Panel to turn the
Vacuum Sealer "ON". The ON/OFF
Button on the display will illuminate and
the Internal Cooling Fan will run.
3. Insert one end of the accessory hose into the Accessory Port on the Vacuum
Sealer.
4. Insert the other end of the accessory hose into the port on the lid of the
canister.
5. Fill the canister with the product to be marinated.
6. Turn the knob/dial on the canister to the seal position.
7. The MARINATE Button (FIGURE 15) has two settings:
10-MINUTE MARINATE PROCESS: Press the MARINATE Button once.
There are a series of seven lights on the bottom right corner of the Control
Panel (FIGURE 15) that indicate the VACUUM PROGRESS. Three lights in
the VACUUM PROGRESS bar will illuminate. This will engage the 10 Minute
Marinate Process.
a. Press the START Button to begin the marinating process.
b. The Vacuum Sealer will begin a process of vacuum and rest. The vacuum
will start for about 25 seconds, followed by a brief 3 ½ minute rest period.
The unit will go through a cycle of (3) 3 ½ minute rests and (3) 7 second
vacuum periods.
20-MINUTE MARINATE PROCESS: For deeper marinade penetration, use the
20-Minute Marinate Process. Press the MARINATE Button twice. There are a
series of seven lights on the bottom right corner of the Control Panel (FIGURE 15)
that indicate the VACUUM PROGRESS. Six lights in the VACUUM PROGRESS
bar will illuminate. This will engage the 20 Minute Marinate Process.
a. Press the START Button to begin the marinating process.
b. The Vacuum Sealer will begin a process of vacuum and rest. The vacuum
will start for about 25 seconds, followed by a brief 6 ½ minute rest period.
The unit will go through a cycle of (2) 6 ½ minute rests and (2) 7 second
vacuum periods. The Vacuum Sealer will finish with (1) 3 minute rest
period and a 7 second vacuum period.
8. To test vacuum, gently tug on the canister lid. The lid should not move.
9. To release the vacuum and open the canister, turn the knob/dial on the canister
to the open position.
10. Press the ON/OFF Button on the Control Panel to turn the Vacuum Sealer
"OFF".
11. Disconnect the Vacuum Sealer from the power supply.
(SOLD SEPARATELY)
Control Panel
FIGURE 15
13