Weston 65-0501-W Mode D'emploi page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8. The SEAL Button will automatically light up when the bag is sealing. The
appliance will stop automatically and "BEEP" when the vacuum and seal
processes are complete. There are a series of seven lights on the bottom right
corner of the Control Panel (FIGURE 6) that indicate the VACUUM/SEAL
PROGRESS.
Press the ON/OFF Button to stop the vacuum process at any point.
9. DO NOT try to open the Vacuum Lid before the vacuum has released or
damage may occur. Press both of the Lid Release Buttons (FIGURE 7) on each
side of the Vacuum Sealer to release the lid lock, then lift the Vacuum Lid to
open.
10. Remove the vacuum sealed bag. Wait at least 20 seconds before sealing
another bag to avoid overheating the unit.
11. Press the ON/OFF Button (FIGURE 6) on the Control Panel to turn the
Vacuum Sealer "OFF".
12. Disconnect the Vacuum Sealer from the power supply before leaving the
work area and when work is complete.
10

Publicité

Table des Matières
loading

Table des Matières