Automatic Mode Operation - Weston PRO-3000 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

AUTOMATIC MODE OPERATION

BEFORE ATTEMPTING
VACUUM PACKAGING BE
SURE THAT THE VACUUM
SEALER IS SET UP IN
ACCORDANCE WITH ALL OF
THE SAFETY PRECAUTIONS
LISTED IN THIS BOOKLET.
1. With the Vacuum Sealer
plugged in and the power
turned on, check to be sure the
Auto Mode Light is illuminated;
press the Mode Button until the
auto light is on (FIGURE 4).
2. Place the items to be vacuum
sealed into a vacuum bag.
Allow at least 2" (5 cm) at the
open end of the bag in order to
create enough seal space. Be
sure not to cover the Vacuum
Port (FIGURE 5).
3. Close the Clear Acrylic
Vacuum Lid and check that the
bag opening is in the center of the Vacuum Chamber (FIGURE 5).
4. Press and release the Start Button. The 2-Piston Vacuum Pump will begin
removing air from the bag while the LED Vacuum Window begins to count up.
You may need to apply light pressure to the Clear Acrylic Vacuum Lid during
the count-up process. The LED Vacuum Window will count up starting at the
number "1" and going thru to the number "9", before automatically engaging
the bag sealing process. (These numbers represent stages, not seconds.)
5. Once the LED Vacuum Window displays the number "9", the sealing
process will begin by counting down from the seal set time to "0" on the LED
Seal Window.
6. Once the LED Seal Window has reached "0", the Vacuum Sealer will
automatically stop the 2-Piston Vacuum Pump and release the vacuum
pressure moments later. DO NOT ATTEMPT TO PULL THE CLEAR
ACRYLIC VACUUM LID OPEN BEFORE THE VACUUM HAS BEEN
RELEASED, SEVERE DAMAGE TO THE SEALING BAR WILL RESULT.
NOTE: The Vacuum Sealer is ONLY intended to be used with VACUUM BAGS. For
best results, only use the recommended vacuum bags with an embossed or mesh lining.
DO NOT USE HOUSEHOLD BAGS! Any other uses of the Vacuum Sealer, other
than the uses described in this booklet, could potentially damage the appliance and void
the warranty!
Mode
Button
Leave 2"
Seal
Space
FIGURE 4
Automatic
Mode Light
FIGURE 5
Vacuum
Ports
Bag in Center of
Vacuum Chamber
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

65-0401-w

Table des Matières