Weston 65-0501-W Mode D'emploi page 15

REPLACING THE VACUUM
CHAMBER LID SEAL:
1. Press the ON/OFF Button on the
Control Panel to turn the Vacuum Sealer
"OFF".
2. Disconnect the Vacuum Sealer from
the power supply.
3. Make sure the Vacuum Sealer is
completely cool.
4. Press both of the Lid Release
Buttons on each side of the Vacuum
Sealer to release the lid lock, then lift
the Vacuum Lid to open.
5. Remove the Vacuum Chamber Lid
Seal from the groove in the Plastic Lid
Base (FIGURE 18).
NOTE: The Vacuum Chamber Lid
Seal has an adhesive backing-if the
adhesive does not remove cleanly from
the plastic, use a gentle, household
adhesive remover. Make sure the
surface is dry and oil free before
replacing with the new Vacuum
Chamber Lid Seal.
6. Peel off the backing from the
Vacuum Chamber Lid Seal. Position
the new Vacuum Chamber Lid Seal into
the groove in the Plastic Lid Base.
7. Work the Vacuum Chamber Lid Seal into the groove with your fingers until
the seal is completely in place and hold for 30 seconds. Wait for 30 minutes
before using.
REPLACING THE LID ASSEMBLY:
1. Press the ON/OFF Button on the Control Panel to turn the Vacuum Sealer
"OFF".
2. Disconnect the Vacuum Sealer from the power supply.
3. Make sure the Vacuum Sealer is completely cool.
4. Press both of the Lid Release Buttons on each side of the Vacuum Sealer
to release the lid lock, then lift the Vacuum Lid to open.
5. Using a Phillips-head screwdriver, remove the 4 Lid Screws in the Plastic
Lid Base (FIGURE 19).
NOTE: Short, narrow diameter or angled screwdrivers work best for removing
the screws.
Plastic Lid Base
Vacuum
Chamber
Lid Seal
Lid Screws
FIGURE 18
FIGURE 19
15