Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING!
Sealer, make sure the Vacuum Sealer is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
There are two factory-installed
Oval Chamber Seals on the
Vacuum
Sealer
When the Vacuum Lid is closed
they form an airtight seal so
the Vacuum Chamber can be
evacuated.
The
Oval
Chamber
may
wear
over
require replacement.
"Maintenance
Kit"
this manual for information on
Oval
replacing
the
Chamber Seals, if necessary.
THERMAL OVERLOAD PROTECTOR
The Vacuum Sealer will automatically shut down if it overheats. If this occurs, turn
the unit off and open the Vacuum Lid. Resume normal operation after the unit cools
or about 20 minutes.
To help prevent overheating, wait at least 20 seconds between cycles with the
Vacuum Lid open. Avoid touching the Seal Bar Tape. The Seal Bar Tape will
remain hot for a brief period of time after each sealing cycle.
CARE & CLEANING INSTRUCTIONS
.
NEVER IMMERSE the Vacuum Sealer in water or other liquid.
.
Make sure the Vacuum Sealer has completely cooled before cleaning it.
.
Wipe clean all outside surfaces including the Plastic Vacuum Chamber and
Vacuum Lid with a damp cloth or paper towel. Most household spray cleaners are
safe to use. Avoid spraying directly into the vent on the left side of the unit. DO NOT
use abrasive cleansers!
.
Be careful while cleaning not to peel or damage the strip of Seal Bar Tape
covering the Seal Bar Heating Element.
.
Dry all surfaces and close the Vacuum Lid before storing the Vacuum Sealer.
Before cleaning, assembling or disassembling the Vacuum
VACUUM CHAMBER SEALS
(Figure
2).
Oval
Chamber
Seals
Seals
time
and
See the
section
of
Vacuum
-6-
Figure 2
Publicité
Table des Matières
Dépannage
