Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fasten the front frame support to the front frame with
two allen screws (
A
FRONT FRAME
1.
Connect the cords from the front and rear frame tube
with each other.
2 .
Connect the frame tubes with each other.
PLEASE NOTE:
Do not damage the console cord!
3 .
Tightly fasten the frame tubes with four allen screws
(
C
).
HANDLES
1.
Remove the holder from the shaft end.
2 .
Set the handle at the end of the shaft and thread the
adjustment key cord from the handle over the shaft into
the front frame tube.
4
) and base plates (
B
).
3 .
Lock the handle by fastening the base plate (
the allen screw (
E
) at the end of the shaft.
PEDAL CRANKS
1.
Push the right pedal crank forward to push the
fastening tube at the front of the pedal crank into the
handle.
2 .
Fasten the fastening tube to the handle with the
screw (
F
). Place the decorative plug over the screw (
3 .
Repeat instructions 1 and 2 for the left handle and
pedal crank.
4 .
Place the plastic covers onto the handle fastening sites
and fasten them with screws (
D
) and
G
).
H
).
Publicité
Chapitres
Table des Matières
