Dometic CoolAir SP950I Notice D'utilisation page 18

Using the parking cooler
7.6 Switching off the parking cooler
You can switch the parking cooler to standby mode or switch it off completely. Note
that the parking cooler consumes power in standby mode. Therefore, switch off the
SP950 parking cooler with SP950I rear panel evaporator unit whenever possible.
Due to the design, the condensation must be pumped off from the SP950 parking
cooler with SP950T roof evaporator unit. Therefore, switch the SP950 parking
cooler with SP950T roof evaporator unit to standby mode after use and any
subsequent journey while in motion. The condensation which accumulated during
and after operation is then drained off.
Switch off the parking cooler completely when it is not in use and for longer periods
(e. g. over the weekend).
I
NOTE
You can only use the remote control to switch the parking cooler in and
out of standby mode.
➤ Switching to standby mode:
With the unit switched on, briefly press the
remote control.
✓ The digital display goes out, only the blue power LED lights up.
✓ The compressor and the fan switch off.
➤ Switching the unit off completely:
With the unit switched on, press the
✓ The LEDs and digital display go out.
✓ The fan and the compressor switch off.
18
button or the
button for 3 seconds.
CoolAir SP950
button on the
EN