Location; Lifting Instructions; Electrical Supply - ESAB EMP235ic Manuel D'instructions

4 INSTALLATION
4.1

Location

Position the power source so that its cooling air inlets and outlets are not obstructed.
4.2

Lifting instructions

The power source can be lifted using any of the handles.
Secure the equipment - particularly if the ground is
uneven or sloping.
4.3

Electrical supply

The supply voltage should be 230 V AC ±10% or 120 V ±10%. Too low supply voltage may
cause poor welding performance. Too high of welding supply voltage will cause components
to overheat and possibly fail. Contact the local electric utility for information about the type of
electrical service available, how proper connections should be made, and inspection
required.
0463 479 001
A. 4 in. (100 mm)
B. 4 in. (100 mm)
- 16 - © ESAB AB 2017