Section 3 Installation; General; Equipment Required; Location - ESAB Powercut 650 Manuel D'instructions

SECtIoN 3
3.0

gENErAl

Proper installation can contribute materially to the satisfactory and trouble-free operation of the POWERCUT
650 cutting package. It is suggested that each step in this section be studied carefully and followed as
closely as possible.
3.1

EquIPMENt rEquIrED

A source of clean, prefiltered dry air that supplies 118 l/m @ 5.5 bar (250 cfh at 80 psig) is required for the
cutting operation. The air supply should not exceed 10.3 bar (150 psig), the maximum inlet pressure rating
of the air filter-regulator supplied with the package.
3.2

loCAtIoN

Adequate ventilation is necessary to provide proper cooling of the POWERCUT 650 and the amount of dirt,
dust, and excessive heat to which the equipment is exposed, should be minimized. There should be at least
one foot of clearance between the POWERCUT 650 power source and wall or any other obstruction to allow
freedom of air movement through the power source.
Installing or placing any type of filtering device will restrict the volume of intake air, thereby subjecting the
power source internal components to overheating. The warranty is void if any type of filter device is used.
3.3

INSPECtIoN

A. Remove the shipping container and all packing material and inspect for evidence of concealed dam-
age which may not have been apparent upon receipt of the POWERCUT 650. Notify the carrier of any
defects or damage at once.
B. Check container for any loose parts prior to disposing of shipping materials.
C. Check air louvers and any other openings to ensure that any obstruction is removed.
103
INStAllAtIoN