How To Navigate - Em235Ic; Symbol Reference Em235Ic - ESAB EMP235ic Manuel D'instructions

6 CONTROL PANEL
6.2

How to navigate - EM235ic

NOTE!
Third party spool guns cannot be used with the EM235ic. The EM235ic only
operates with Rebel spool guns.
6.2.1

Symbol reference EM235ic

Overtemperature
Spool Gun
Smart MIG
0463 479 001
1. Spool gun indication: Symbol
illuminates when spool gun is
connected.
2. Over temperature indication:
Symbol illuminates when product is
overheated.
3. Volt/Amp display: LED displays the
Volts and Amps values during
welding. It holds the last used
parameter.
In sMIG "V" displays the wire
diameter while idle "A" displays the
set wire feed speed.
4. Voltage knob: Adjust the voltage
value (in sMIG not functional).
5. Knob for plate thickness or wire
feed speed: in sMIG mode (outer
circle, in yellow) plate thickness can
be adjusted. Wire feed speed can
be adjusted when in manual
MIG/MAG or flux cored (inner circle,
in white).
6. Process selection knob: Enables
selection between sMIG mode (left,
in yellow) and manual MIG mode
(right, in white).
Volts (manual MIG mode only)
Amps
Wire feed speed
- 34 - © ESAB AB 2017