Installing The Arm Covers - Shimano Steps EP800 Série Mode D'emploi

INSTALLING THE DRIVE UNIT AND PERIPHERAL PARTS

Installing the arm covers

(2) Tighten the clamp screw.
12 - 14 N·m
(2) Clamp screw (x 2)
(1) Cross-section
Stopper plate
Plate pin
NOTICE
• Set the stopper plate in the correct direction as shown in figure.
Cross-section
Bicycle side Outward
Installing the arm covers
If arm covers are included with the chainring, install the arm covers after installing the
chainring to the drive unit.
39