Shimano Steps EP800 Série Mode D'emploi page 29

TO ENSURE SAFETY
„ For installation to the bicycle, and maintenance:
• Be sure to remove the battery and charging cable before wiring or attaching parts to the
bicycle. Failure to do so may cause an electric shock.
• Clean the chain with an appropriate chain cleaner regularly. Intervals between
maintenance depend on the use and riding circumstances.
• Never use alkali based or acid based solvents, such as rust cleaners. If those solvents are
used the chain might break and cause serious injury.
„ Disposal precautions
• Observe all federal, state and local environmental regulations when disposing of a cycle
computer that incorporates a battery. Disposal of this product into fire or a hot oven, or
mechanically crushing or cutting of it, that can result in an explosion of the incorporated
battery.
CAUTION
Be sure to also inform users of the following:
• Observe the instructions in the manual for the bicycle in order to ride safely.
• Periodically check the battery charger and adapter, particularly the cord, plug, and case,
for any damage. If the battery charger or adapter is damaged, consult the place of
purchase.
• Use the product under the supervision of someone responsible for safety, and only as
instructed. Do not allow anyone (including children) with reduced physical, sensual, or
mental capacity, or those without experience or knowledge, to use the product.
• Do not allow children to play near the product.
• Never modify the system. Doing so may cause a system error.
„ Lithium-ion battery
• Do not leave the battery in a place exposed to direct sunlight, inside a vehicle on a hot
day, or other hot places. This may result in battery leakage.
• If any leaked fluid gets on your skin or clothes, wash it off immediately with clean water.
The leaked fluid may damage your skin.
• Store the battery in a safe place out of the reach of children.
7