Integrated Mount Type - Shimano Steps EP800 Série Mode D'emploi

INSTALLING ELECTRICAL PARTS
Names of parts

Integrated mount type

(O)
(I)
(A)
Built-in type battery*1
(C)
Drive unit
(E)
Crank arm
(G)
Speed sensor*2
(I)
Disc brake rotor
Switch unit (shifting switch) or shifting
(K)
lever
(M)
Electric wire
(O)
Battery charger
*1 Attach the battery mount and battery inside the frame. Depending on the assist bicycle, the battery may be
installed at a location different from the position specified in the figure.
*2 Attach it to one of the two locations specified in the figure.
*3 Electronic gear shifting: DI2 rear derailleur or motor unit + DI2 internal geared hub
Mechanical gear shifting: rear derailleur or internal geared hub
(N)
(G)
(H)
(G)
(C)
(D)
(E)
(F)
(B)
(D)
(F)
(H)
(J)
(L)
(N)
14
(J) (L) (K)
(M)
-
Drive unit cover (left side and bottom
side)
Chainring unit
Shifting unit*3
Switch unit (assist switch)
Cycle computer or junction [A]
Chain device
(A)