Removal Method; Connecting Cockpit Peripheral Parts And Electronic Gear Shifting Components - Shimano Steps EP800 Série Mode D'emploi

INSTALLING THE DRIVE UNIT AND PERIPHERAL PARTS

Connecting cockpit peripheral parts and electronic gear shifting components

Removal method

1.
Remove the power cord.
Hold the groove on the plug and slide the tip of the plug to pull it out, as shown in the
figure.
Plug part of power cord
(when connected with the DU)
Connecting cockpit peripheral parts and
electronic gear shifting components
Connect wires from the cycle computer and electronic gear shifting components to the drive
unit's terminal block.
When disconnecting the plug
Plug part
29
Plug part