Conversion Adapter; Connecting / Disconnecting The Electric Wire - Shimano Steps EP800 Série Mode D'emploi

INSTALLING ELECTRICAL PARTS
Electric wires

Conversion adapter

A conversion adapter (EW-AD305) is required to connect the EW-SD50 to a component with an
E-TUBE port for the EW-SD300.
Electric wire (EW-SD300)

Connecting / disconnecting the electric wire

Be sure to use the SHIMANO original tool to remove and insert electric wires.
NOTICE
• When connecting and disconnecting electric wires, do not forcibly bend the plug part.
It may result in a poor connection.
` Connecting the electric wire (EW-SD300)
Connect the electric wire to the E-TUBE port.
1.
Set the plug of the electric wire to the TL-EW300.
If there is an alignment tab on the plug of the electric wire, check the shape of the
E-TUBE port you are trying to connect to, and set it aligned with the alignment tab.
Without alignment tab on plug
Groove
Conversion adapter (EW-AD305)
Guide
Electric wire (EW-SD50)
18