Replacing The Lamps - Novy 7500/6 Mode D'emploi Et D'installation

The monoblock filters are placed behind the
grease filter
Programming the saturation indication
(Attention! Programming can only take place
when the hood is switched off)
• push + and - at the same time, during 5 min..
(the red led will blink 5 times)
• delay time is programmed for 30 minutes
(instead of 10 min.).
• the saturation indication is programmed (200
working hours).
After 200 working hours the red LED will blink
(time to reactivate the monoblock filter)
Reprogramming of the saturation indication.
(Attention! Programming can only take place
when the hood is switched off)
• push + and - at the same time, during 5 min..
(the red led will blink 5 times) or automatically
after pressing 10 times the on/off button 0/I
Deactivating the saturation indication (Atten-
tion! Programming can only take place when
the hood is switched off)
• push + and - at the same time, during 5 min..
(the 3rd green LED will blink 5 times)
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood. Use a soft, wet cloth
and a mild detergent to clean the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.
7500-6 Gebruik NL-DE-FR-EN.indd 20

Replacing the lamps

Please allow the lights to cool down sufficiently
before touching them. Cover and protect delicate
surfaces underneath the hood when changing
lamps.
Replace the lamps:
• attach the suction device to the lamp
• pull towards you
• put a new lamp in place using the same suc-
tion device
The hood has 2 lamps of the following type:
12V/20W/Ø35/GU4/38°
EN 20
21/05/13 17:34