Replacing The Lamps; Electrical Connection - Novy 706/1 Mode D'emploi Et D'installation

Maintenance
Maintenance of the grease filter
The hood contains one or two metal filters which
should be cleaned twice a month.
Access to the filter
Take hold of the right and left side of the plate (a)
and pull down simultaneously.
Remove the filter (b) by taking hold of its hook and
pulling down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood.
Use a soft, wet cloth and a mild detergent to clean
the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.

Replacing the lamps

Please allow the lights to cool down sufficiently
before touching them. Cover and protect delicate
surfaces underneath the hood when changing
lamps.
If the TL-lamp needs replacing you can take out
the glass plate at the front by unscrewing the two
screws at the back of the glass plate.
For the hoods of 60 cm the TL-lamp is 15 Watt,
for the hoods of 90 and 100 cm it is 18 Watt.

Electrical connection

Electrical output: electrical cord + plug with
ground. To be plugged into socket with ground.
Check for compatibility with information on type
plate (behind filter).
Socket must be within reach.
Changes or replacement of the electrical cord
should be performed by a professional only.
Dimensions: p. 19
Electrical scheme: p. 20
EN 13