Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
fan is blocked or an object is (partly) closing off
the exhaust opening.
Maintenance
Maintenance of the grease filter
The hood contains one or 2 metal filters (according
to the model) which should be cleaned twice a
month.
Grease filter indication
After 20 cooking hours, the 4 speed indicator
lamps will start to blink during 5 minutes, this
indicates that the grease filter has to be cleaned.
When replacing the cleaned filter, you have to
reset the hood by pushing the – button during 5
seconds . If you don't reset, the speed indicator
lamp lights will continu blinking.
Access to the filter
Take hold of the right and left side of the plate (a)
an pull down simultaneously. Remove the filter (b)
by taking hold of its hook and by pulling it down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a liquid
detergent. Rince and allow to dry completely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood. Use a soft, wet cloth
and a mild detergent to clean the hood. Never
use aggressive, abrasive detergents or sponges.
Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.
Replacing the lamps
Please allow the lights to cool down sufficiently
before touching them. Cover and protect delicate
surfaces underneath the hood when changing
lamps. The hood needs to be disconnected from
the current before proceeding.
1. Open the bottom plate and then loosen the
screws and slide off the cover.
2. Removing the LED lamp:
A. First disconnect the cable to the LED to be
replaced. Disconnect by means of releasing
the lock, by applying light pressure while at
the same time pulling away.
B. Next, remove the LED to be replaced by
making a gentle rotating movement to the left.
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until
the LED light is locked.
C. Connect the power cable.
D. Put back the cover and tighten the screws.
Then close the bottom plate.
EN 16
Publicité
Table des Matières
