Replacing The Led Lighting - Novy 661/16 Mode D'emploi Et D'installation

Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood.
Use a soft, wet cloth and a mild detergent to clean
the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.
Recirculation (option)
If you have chosen for recirculation, please follow
the instructions below.
Cleaning:
With normal use (1 to 2 hours daily), regenerate the
Monoblock recirculation filter every six months.
Remove the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• The Monoblock recirculation filter is found in
its opening in the cooker hood. Remove it from
the cooker hood.
Regenerate the Monoblock recirculation filter:
• The Monoblock can be regenerated up to 12
times. This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C.
Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released. Smells can be released when baking
certain kinds of fish. The best solution for this is
to immediately regenerate the filter.
Place the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• Place the Monoblock recirculation filter is its
opening in the cooker hood.
• Put back the aluminium grease filter and close
the bottom plate.

Replacing the led lighting

First, remove the power supply from the hood
and allow the lighting to cool down sufficiently.
1. Carefully press the spotlight holder; next,
remove the spotlight holder by means of a
tilting movement.
1. Open de bottom plate and then loosen the
screws and slide the cover forward and
downward to loosen it from the cooker hood.
2. Removing the LED lamp:
A. First disconnect the cable to the LED to be
replaced. Disconnect by means of releasing
the lock, by applying light pressure while at
the same time pulling away.
B. Next, remove the LED to be replaced by
making a gentle rotating movement to the left.
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until
the LED light is locked.
C. Connect the power cable.
D. Put back the cover and tighten the screws.
Then close the bottom plate.
EN 16