Replacing the lamps
Please allow the lights to cool down sufficiently before
touching them. Cover and protect delicate
surfaces underneath the hood when changing lamps.
The hood needs to be disconnected from
the current before proceeding.
1. Open the bottom plate and then loosen the screws
and slide off the cover.
2. Removing the LED lamp:
A. First disconnect the cable to the LED to be
replaced. Disconnect by means of releasing the
lock, by applying light pressure while at the same
time pulling away.
B. Next, remove the LED to be replaced bymaking a
gentle rotating movement to the left.
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until the LED
light is locked.
C. Connect the power cable.
D. Put back the cover and tighten the screws. Then
close the bottom plate.
Electrical connection
Electrical output: electrical cord + plug with ground. To
be plugged into socket with ground.
Check for compatibility with information on type plate
(behind filter). Socket must be within reach. Changes or
replacement of the electrical cord should be performed
by a professional only.
Dimensions: p. 18
Electrical scheme: p. 19
EN 13