Night Light™ Replacement (Gdig3 / Gdix3) - Napoleon Oakville Serie Manuel D'installation

6.6 night light™ replacement (GDIG3 / GDIX3)
Your appliance comes equipped with our "Night Light™". The light has been pre-wired and is controlled from the
remote control.
If the lamp or lens needs to be replaced, follow the instruc-
tions below.
Unplug the appliance (plug located on right side of
A.
appliance).
Remove the 2 screws holding the light shield in
B.
place.
Remove the 4 screws that secure the lens frame
C.
(Fig. 1). This frame retains the glass lens. The lamp
can now be accessed.
note:
Do not handle the lamp (bulb) with bare fingers.
Protect them with a clean, dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as lamp
and lens are special "high temperature" products. When re-installing, ensure integrity of
gasket seal.
f i r e - p a r t s . c o m
THE FIREBOX MUST BE SEALED.
Over-tightening the screws could break the lens. "Light Leakage" from the upper area
may be observed. The holes in the lamp housing are necessary for ventilation and must
not be covered.
maintenance
Bottom of Appliance
W415-1802 / B / 02.07.19
EN
Fig. 1
GASKET
LENS
FRAME
31