Charcoal Embers; Battery Installation (Gdig3 / Gdix3); Receiver Removal - Napoleon Oakville Serie Manuel D'installation

3.7

charcoal embers

WARNING
!
• Do not block or close off the burner ports. Blocked ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition.
• When supplied, charcoal embers, charcoal lumps and vermiculite are not to be placed on the burner.
Randomly place the charcoal embers along the front and sides of the log support in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
note:
Charcoal embers are not to be placed on the burner.
3.8

battery installation (GDIG3 / GDIX3)

4 AA batteries must be installed into the receiver before the appliance can operate by battery backup. The re-
ceiver is located in the bottom right corner of the appliance (Fig. 1).
f i r e - p a r t s . c o m
GDIG3 Illustrated
3.9

receiver removal

1. Remove the right access panel from the side of the
appliance.
2. Remove the front 2 screws from the inside edge (Fig.
2) and swing the control door open.
note:
If your opening is too small, you may need to
pull the appliance out slightly.
3. Remove the 2 screws holding the receiver in place.
4. Remove the receiver and replace.
Fig. 1
finishing
22.2
note:
Ensure the 3 position slider
switch is in the "REMOTE"
position (middle position).
W415-1802 / B / 02.07.19
EN
Fig. 2
23