GS PAX TIRE CHANGER Manuel De L'opérateur page 51

Fitting
Fitting
Place the dose of Gel on
Lubricate the Beads of the
Insert the Support Ring into
Lubricate the whole width
Install the Support Ring up
by pushing with the roller
while the assembly is rotating.
Disengage the Inner Bead
Place the Roller up against
the Rim. Fit the Outer Bead
of the Tyre on the Rim seat.
PAX TIRE CHANGER
1
the inside of the Tyre
and use the Scraper
to spread it out.
2
Tyre with a Car Tyre
Lubricant.
3
the Tyre, taking care
to comply
with the fitting direction.
4
of the Rim.
5
against the Wheel Stop
6
of the Tyre from the Rim
Well using the Lever.
7
8
Fit the Inner Bead
of the tyre
in the same way.
9
Make sure that the Tyre
is correctly in place
when inflated and, lastly,
screw on the Valve Cap.
Removal
Removal
1
Deflate the Tyre.
2
Push the Bead using
the Roller to allow lubrication
of the inner edge
of the Rim.
3
Push the Inner Bead
of the Tyre into the Rim
Well using the Roller
and rotation
of the assembly.
4
Push the Bead using
the Roller to allow lubrication
of the outer edge
of the Rim.
5
With the assembly rotating,
insert the Strip into the space
created by the Roller
between the Tyre
and the Rim.
6
Insert the Lever
into the notch of the Strip
and remove the Outer Bead.
7
Disengage the Tyre
and the Support Ring
by pushing with the Roller
while the assembly
is rotating.
8
To finish, extract the
Support Ring manually
or by using the Lever.
51