Operations; Basic Operations - Clarion DXZ588RUSB Mode D'emploi

01_DXZ588RUSB_EN.book 13 ページ ２００７年１１月２７日 火曜日 午後６時５分

6. OPERATIONS

Note:
• Be sure to read this chapter referring to the front diagrams of chapter "3. CONTROLS" on page 6.

Basic Operations

CAUTION
Be sure to lower the volume before
switching off the unit power or the ignition
key. The unit remembers its last volume
setting. If you switch the power off with the
volume up, when you switch the power back
on, the sudden loud volume may hurt your
hearing and damage the unit.
Turning on/off the power
Note:
• Be careful about using this unit for a long time
without running the engine. If you drain the car's
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the [SRC] button.
The mode that was previous active is
displayed.
2. Press and hold the [SRC] button for 1
second or longer to turn off the power for the
unit.
Note:
• The first time this unit is turned on after the wire
connections are completed, it must be checked
what equipment is connected. When the power
is turned on, the "SYSTEM CHECK" appears in
the display. The system check starts within the
unit. When the system check is complete, the unit
returns to the radio mode.
Selecting a mode
1. Press the [SRC] button to change the
operation mode.
2. Each time you press the [SRC] button, the
operation mode changes in the following
order:
Radio CD/MP3/WMA/AAC
iPod (TELEPHONE)
AUX Radio...
∗ External equipment not connected with
CeNET is not displayed.
∗ iPod/MTP can connect to this unit via USB
SLOT.
Adjusting the volume
1. Press the [+] or [–] button to adjust the
Switching the display
1. Press the [D] button to select the desired
USB/MTP/
(CD changer)
volume.
∗ The volume level is from 0 (minimum) to 33
(maximum).
display.
∗ When CT data is not received, "CT– –:– –"
appears in the display.
DXZ588RUSB
13